9 points for attention in the use of CNC cutting machine?

As a CNC machine, CNC cutting machine has relevant operating procedures in operation and use. Operators are required to strictly follow the operating procedures to avoid machine failures and personal injuries caused by irregular operations. This article briefly lists CNC cutting from the following 9 aspects What are the precautions for machine operation?

1. After setting the engraving position, the X, Y, and Z axis workpiece coordinates must be classified as "0".

2. Adjust the engraving speed and the rotation speed of the spindle motor to prevent the tool from breaking when the speed is too fast or too slow.

3. During automatic tool setting, pay attention to the insulation between the tool setting block and the CNC router aluminum table.

4. When engraving, if you are not sure or afraid of making mistakes, you can slow down the feed speed, and then adjust the speed back to normal when you feel that the engraving is normal; you can also simulate engraving in the idle process to see if it is normal.

5. If the CNC cutting machine is not used for a long time, it should be refueled and run idly every week, every week, to ensure the flexibility of the transmission system.

6. The continuous running time of CNC cutting machine is required to be less than 10 hours/day; the cleaning of cooling water and the normal operation of the water pump must not cause water shortage in the water-cooled spindle motor. Change the cooling water regularly to prevent excessive water temperature and circulating water as much as possible Many, you can change a large-capacity water tank.

7. After using the CNC cutting machine each time, pay attention to cleaning. The dust on the platform and transmission system must be cleaned; regularly lubricate the X, Y, and Z axes of the transmission system.

8. Operators should wear dust masks and protective glasses when operating the CNC cutting machine, so that the dust generated during processing can invade the human body and cause discomfort.

9. The daily maintenance method of CNC cutting machine should be equipped with dust-proof and dust-removing device on the CNC cutting machine, and the dust-removing equipment should be used together.