Solutions to common problems of CNC cutting machine for panel furniture?

       Now the use of CNC cutting machine equipment is very popular, CNC cutting machine has some common problems, then how to solve these problems so that the machine can serve us well? In fact, these problems are often caused by improper maintenance of the machine. Because some customers do not understand the mechanical principle, the machine will look like a machine after they are bought. They want to use it 24 hours a day without stopping, and can’t let it "idle", Therefore, the maintenance of the machine is neglected, so the situation is full. Let's list the common problems of the machine below.

       Spindle motor, servo motor and other accessories are burnt out: This problem is often caused by the voltage instability in the circuit. In some areas, the power consumption peaks and the voltage is too low, which causes the accessories to burn out. Customers can purchase a voltage regulator to solve the problem.

       Track damage: Track damage is often caused by customers not filling lubricating oil regularly or not cleaning up debris on the track in time. After using the CNC cutting machine or using air guns and other equipment in the working gap, Clean up the foreign matter in the track, and pay attention to filling the track with lubricating oil regularly.
      Interruption of the knife during work: This is a problem that customers often encounter, because if a knife breaks, then the work is forced to be interrupted, and the tool change takes time, so what is The reason for the broken tool is that the quality of the tool is not good, and the price of the tool is also very different. Some customers buy inferior tools to save money and encounter resistance. The tools are naturally prone to damage. Secondly, the speed is too fast. Although the configuration of the CNC cutting machine is already very high and can work at the preset speed, the tool cannot withstand the speed of the machine, so it often breaks. The second is the plate. If the plate is a low-quality product , There are sundries in the middle, and problems often occur during cutting. Therefore, it is necessary to use high-quality tools, set the working speed, and use qualified plates to avoid the problem of tool breakage as much as possible, and if the tool wears seriously, it must be timely Change the tool to prevent accidental breakage